SLAAC Prefixes with Variable Interface ID (IID)

The lowest common denominator method of configuration for IPv6 nodes is SLAAC , which is carefully designed to allow any prefix length and any interface identifier (IID) length, provided that they do not total more than 128 bits. Until now, specifications of "IPv6 over foo" mappings, starting with , have specified an IID length of 64 bits, consistent with the value specified by . This document allows a router to announce an IID length other than 64 on a given link, and updates RFC , (and numerous other "IPv6 over foo" documents TBD), and accordingly. It extends by defining a new "IID length" mechanism in RA messages.

Terminolgoy used in defining the IPv6-Only Edge specification. Modified Host: Supports this specification Unmodified Host: Does not support this specification

The predefined IID length specified by , , etc. is used to configure the link-local IPv6 address of a node exactly as described in . On a link where variable IID length is not supported, the predefined IID length will continue to be used to configure all other addresses using SLAAC. On a link where variable IID length is supported, each modified router will include an "IID length" indication in every RA/PIO message with the A bit set. This will override the value defined in (etc.) and in , for the prefix concerned. In this variable IID specification it is recommended to put the IID length in the 6 bits of the Reserved2 field of the PIO. 0b000000 would mean 64, i.e. no change and backwards compatible. Any other value would define an IID length in bits. Values less than 48 (0b110000) are NOT RECOMMENDED. Values greater than 64 are impossible. (Note: Reserved1 is not available - see .) When a modified node receives an "IID length" less than 64, it will use that value instead of the default for all unicast address autoconfiguration under that prefix, except link-local.

- Unmodified hosts and unmodified routers: no change, all use 64-bit IIDs. - Modified hosts and unmodified routers: no change, all use 64-bit IIDs. - Modified hosts and modified routers: configure to use longer prefixes and shorter IIDs if desired. Modified routers and mixture of modified and unmodified hosts on a link: The modified hosts will use a shorter IID and longer prefix if that is announced. The unmodified hosts, according to RFC 4861, MUST ignore the Reserved1 field. So, according to section 5.5.3 clause d) of RFC 4862, they will ignore any PIO advertising a shorter IID. Therefore, the operator has two choices: 1. Decide that unmodified hosts will not be supported (i.e. will not be able to configure an address using SLAAC). 2. Announce (at least) two prefixes on the link - a /64 and a longer one, with a shorter IID. For that to make sense, we need an extra rule for modified hosts: if a host receives several PIOs from the same router, it prefers all those with the shortest IID and ignores the others. Mixure of Modifiled and Unmodified hosts router on a link is not recommmended.

The administrator should be aware to maintain 64 bit interface identifier for privacy when connected directly to the internet so that entropy for optimal heuristics are maintained for security. Variable length interface identifier shorter than 64 bits should be used within networks where there there are out-of-band guarantees that the hosts are trusted (e.g. corporate intranets and private networks).

IANA Request for RA PIO registry for RESERVE2

Brian Carpenter.